Panasonic kx-ns500 Pc Programming Manual page 280

9.13 PBX Configuration—[1-1] Configuration—Slot—Card Property—V-IPEXT
During operation, set between 10 s and 60 s. Settings over 60 s, and Disable, are used for debugging purposes,
and IP-PTs cannot be guaranteed to function normally in these circumstances. Do not use debugging settings
unless instructed to do so.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
Disable, 10–120 s
Feature Guide References
5.2.1 IP Proprietary Telephone (IP-PT)
First Resending Time (PTAP)
Specifies the length of time that the PBX waits before starting to resend PTAP (Panasonic Telephony
Administration Protocol) data.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
500 ´ n (n=1–16) ms
Feature Guide References
5.2.1 IP Proprietary Telephone (IP-PT)
Resending Time Out (PTAP)
Specifies the length of time after which the PBX terminates resending PTAP (Panasonic Telephony
Administration Protocol) data.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
150–240 s
Feature Guide References
5.2.1 IP Proprietary Telephone (IP-PT)
First Resending Time (MGCP)
Specifies the length of time that the PBX waits before starting to resend MGCP (Media Gateway Control
Protocol) data.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
500 ´ n (n=1–8) ms
Feature Guide References
5.2.1 IP Proprietary Telephone (IP-PT)
280 PC Programming Manual