Panasonic kx-ns500 Pc Programming Manual page 554

11.12.1 PBX Configuration—[3-12-1] Group—VM(DTMF) Group—System Settings
Others—Call Waiting on VM Group
Enables the queuing of calls when all extension ports of the VM (DTMF) group are busy. (Call Waiting tone is
not sent to any VM port.)
Value Range
Disable, Enable
Feature Guide References
2.2.2.4 Queuing Feature
Others—FWD to the VPS Sequence
Specifies which DTMF commands the VPS receives from the PBX when a call is forwarded to the VPS, so
that the VPS can answer the call either with a mailbox or in the AA service mode. It is also possible to send
no DTMF signal to the VPS.
Value Range
None, Answer by Mailbox, AA
Others—Intercept Routing to the VPS Sequence
Specifies which DTMF commands the VPS receives from the PBX when a call is intercepted to the VPS, so
that the VPS can answer the call either with a mailbox or in the AA service mode. It is also possible to send
no DTMF signal to the VPS.
Value Range
None, Answer by Mailbox, AA
Others—Mailbox for Extension
Specifies whether the mailboxes use the same numbers as the extensions and incoming call distribution
groups, or use different numbers as programmed for each extension or incoming call distribution group.
Value Range
Extension Number, Programmed Mailbox Number
PC Programming Manual References
11.5.1 PBX Configuration—[3-5-1] Group—Incoming Call Distribution Group—Group Settings
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
12.2.1 PBX Configuration—[4-2-1] Extension—Portable Station—Extension Settings
Others—Message Waiting Lamp Control
Specifies whether the PBX or VPS cancels the Message Waiting feature (e.g., turning off the MESSAGE button
light) when an extension user answers the message waiting notification from the VPS.
Value Range
By PBX, BY VM
554 PC Programming Manual