Panasonic kx-ns500 Pc Programming Manual page 326

9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
Value Range
64 + 16 ´ n (n=0–11) ms
Pulse / DTMF Dial—Pulse Inter-digit Pause
Specifies the length of the pulse inter-digit pause. This allows the telephone company to have enough time to
accept the dialled digits correctly.
Value Range
630 ms, 830 ms, 1030 ms
Low Speed Pulse Dial—Pulse % Break
Specifies the % break for a low speed pulse dial. This is the ratio between the break (on-hook) signal and make
(off-hook) signal in a pulse dial.
Value Range
Other, 60%, 67%
PC Programming Manual References
9.24 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
Low Speed Pulse Dial—Break Width
Specifies the maximum length of the break signal in a low speed pulse dial.
% Break on this screen determines the value that can be specified here.
Value Range
20 + (4 ´ n) (n=1–15) ms
PC Programming Manual References
9.24 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
Low Speed Pulse Dial—Make Width
Specifies the minimum length of the make signal in a low speed pulse dial.
% Break on this screen determines the value that can be specified here.
Value Range
4 ´ n (n=3–15) ms
PC Programming Manual References
9.24 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
High Speed Pulse Dial—Pulse % Break
Specifies the % break for a high speed pulse dial. This is the ratio between the break (on-hook) signal and
make (off-hook) signal in a pulse dial.
326 PC Programming Manual
Low Speed Pulse Dial—Pulse
Low Speed Pulse Dial—Pulse