Um Configuration-[4-3] Service Settings-Custom Service-Date Control - Panasonic kx-ns500 Pc Programming Manual

23.3.2 UM Configuration—[4-3] Service Settings—Custom Service—Date Control
23.3.2 UM Configuration—[4-3] Service Settings—Custom
Service—Date Control
The below parameters are set for the Date Control Custom Service in the Custom Service Builder.
This service allows you to assign a different operation for up to 5 time periods. The caller makes no selection
and no menu is announced.
Description
The information typed in this field is for reference only.
Value Range
Max. 32 characters
Feature Guide References
3.2.1.15 Custom Service
Period 1–5, Outside
Period 1–5:
Specifies the name of date period for reference, start and end date, and an operation.
Outside:
Allows you to specify an operation that is enabled on all other dates not included in the set periods.
Value Range
Period 1–5:
Name: Max. 16 characters
From/To: Select the check box, and then click the input field to select a date (month and day) from the calendar.
You can specify a beginning date (From), ending date (To), or both for each period.
Assigned Operation: Trf to Mbx, Trf to Ext, Operator, Trf to Out, Exit, Prev Menu, CS, VM Serv, Call Trf Serv,
Subscriber Serv, Dial by Name, Repeat Menu, Main Menu, Trf to Fax Extn, List All Names, None (see
23.3.1 UM Configuration—[4-3] Service Settings—Custom Service—Menu & Transfer—
Assigned Operation: 0–9, *, #)
Outside:
Name: Max. 16 characters
Assigned Operation: Trf to Mbx, Trf to Ext, Operator, Trf to Out, Exit, Prev Menu, CS, VM Serv, Call Trf Serv,
Subscriber Serv, Dial by Name, Repeat Menu, Main Menu, Trf to Fax Extn, List All Names, None (see
23.3.1 UM Configuration—[4-3] Service Settings—Custom Service—Menu & Transfer—
Assigned Operation: 0–9, *, #)
Feature Guide References
3.2.1.15 Custom Service
810 PC Programming Manual
Key –
Key –