9.29 PBX Configuration—[1-1] Configuration—Slot—Card Property—E1 type Line Signal Setting
9.29 PBX Configuration—[1-1]
Configuration—Slot—Card Property—E1 type Line
Signal Setting
DR2 Setting Type
Selects the control type of the DR2 (Digital System R2) signal.
Value Range
Normal, Option 1, Option 3
Inter-digit Timer
Specifies the pseudo-answer time. This setting is available only when Option 1 or Option 3 is selected in DR2
Setting Type on this screen.
Value Range
3-15
Bit Position for Dial Pulse
Selects the position of the pulse dial control bit in a DR2 signal.
Value Range
A-bit, B-bit
Bit Position for Clear Back
Selects the position of the clear-back signal control bit in a DR2 signal.
Value Range
A-bit, B-bit, A&B-bit
Forced Release
Enables the PBX to send a forced release signal.
Value Range
Disable, Enable
Forced Release Pattern
Selects the bit pattern for a forced release signal.
Value Range
A=0/B=0, A=0/B=1, A=1/B=0, A=1/B=1
Meter Pulse Detection—Mode
Specifies the mode for call charge meter pulses.
PC Programming Manual
361