Pbx Configuration-[2-6-2] System-Numbering Plan-Quick Dial - Panasonic kx-ns500 Pc Programming Manual

10.6.2 PBX Configuration—[2-6-2] System—Numbering Plan—Quick Dial
10.6.2 PBX Configuration—[2-6-2] System—Numbering
Plan—Quick Dial
Quick Dialling numbers are used to call extensions or outside parties, or access certain features without having
to dial their full numbers. It is possible to register Quick Dialling numbers that overlap with other registered
numbers (refer to "Automatic Rerouting of VoIP Calls to Public Trunks" in the Feature Guide).
For more information on flexible numbering, see "5.5.7 Flexible Numbering/Fixed Numbering" in the Feature
Guide.
Use Quick Dial for CO rerouting during "Break" Mode.
Specifies whether Quick Dialling can be used to make a trunk call via an extension registered at another site
in a One-look network, when the Time Service mode is Break mode.
Value Range
On, Off
Feature Guide References
2.6.5 Quick Dialling
5.1.4 Time Service
Use quick dial for rerouting to public CO when TIE line does not work.
Specifies whether Quick Dialling can be used for rerouting to a public trunk when a TIE line is not operating.
Value Range
On, Off
Feature Guide References
2.6.5 Quick Dialling
Dial
Specifies the Quick Dialling number.
Value Range
1–4000: Max. 8 digits (consisting of 0–9, *, and #)
Feature Guide References
2.6.5 Quick Dialling
4.3.2 Voice over Internet Protocol (VoIP) Network
5.5.7 Flexible Numbering/Fixed Numbering
Phone Number
Specifies the number to be dialled when the corresponding Quick Dialling number is used.
438 PC Programming Manual