Panasonic kx-ns500 Pc Programming Manual page 271

Value Range
20 ms, 30 ms, 40 ms, 50 ms, 60 ms
Packet Sampling Time for G.729A
Specifies the time interval between measurements (samples) of sound data during a conversation. The smaller
this number, the higher the quality of the transmitted sound.
Value Range
20 ms, 30 ms, 40 ms, 50 ms, 60 ms
FAX Detection Ability
Enables the use of the FAX Detection Ability feature. Since fax signals using a codec other than G.711 cannot
be received accurately at the destination, this feature automatically switches the codec to G.711 to enable
end-to-end fax signal relay over the network.
Value Range
Disable, Enable
PC Programming Manual References
9.11 PBX Configuration—[1-1] Configuration—Slot—Shelf Property—V-IPGW—Incoming Call—
Codec Priority 1st
FAX Sending Method
Specifies the method of transporting the fax signal.
Value Range
G.711 Inband, T.38
Maximum Bit Rate
Specifies the maximum bit rate of the fax signal.
Value Range
No Speed Limit, 2400 bps, 4800 bps, 7200 bps, 9600 bps, 12000 bps, 14400 bps
DTMF
Specifies the type of DTMF tone to be sent out.
Value Range
Inband, Outband (RFC2833), Outband (H.245)
Payload Type
Specifies the payload type for DTMF tones using RFC2833. Programming this parameter is only necessary if
DTMF is set to Outband (RFC2833).
9.11 PBX Configuration—[1-1] Configuration—Slot—Shelf Property—V-IPGW
Voice
PC Programming Manual 271