Panasonic kx-ns500 Pc Programming Manual page 352

9.27 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port
QSIG-Master: For connecting to private network (master port)
Connection
Indicates the port status. To change the status of the port, click the desired cell in the column, and then select
INS or OUS for the port.
This option is only available in On-line mode.
Value Range
INS: The port is in service.
OUS: The port is out of service.
Fault: The port is not communicating with the network.
Subscriber Number
Specifies the number used as the CLIP number.
Value Range
Max. 16 digits (consisting of 0–9, *, and #)
Feature Guide References
4.1.2.2 Calling/Connected Line Identification Presentation (CLIP/COLP)
Ringback Tone to Outside Caller
Enables the PBX to send a ringback tone to an outside caller when the network cannot send the tone.
Value Range
Disable, Enable
ISDN Outgoing Call Type
Selects the method used to send dialled digits to the network.
Value Range
En-bloc: The PBX sends all of the dialled digits at once after the extension user completes dialling. The PBX
recognises the end of dialling when (1) # is dialled, if programmed, (2) a pre-programmed telephone number
is dialled, or (3) the inter-digit timer expires.
Overlap: The PBX sends dialled digits one at a time.
PC Programming Manual References
9.1 PBX Configuration—[1-1] Configuration—Slot
10.3 PBX Configuration—[2-3] System—Timers & Counters—Dial / IRNA / Recall / Tone—
Inter-digit (s)
10.9 PBX Configuration—[2-9] System—System Options—Option 2—
Dial for en Bloc mode
11.1.4 PBX Configuration—[3-1-4] Group—Trunk Group—Dialling Plan
352 PC Programming Manual
Dial—Extension
ISDN en Bloc Dial—[#] as End of