Edge-Core ECS4110-28T Management Manual page 1469

This command using software to process static routes. Us the no form to
ip sw-route
disable this function.
S
YNTAX
[no] ip sw-route
D
EFAULT
Hardware is used to process static routes.
C
OMMAND
Global Configuration
C
OMMAND
Due to a hardware limitation on the ECS4110-52T, static routes do not
◆
work with DiffServ. Hardware processing of static routes is enabled by
default. If you must use DiffServ, then use this command to configure
the switch to process static routes through software.
The switch can only can only process 200~300 routing packets/second.
◆
So, it should only be used as L3 switch in this mode for light routing
requirements.
E
XAMPLE
Console(config)#ip sw-route
Console(config)#
This command displays information in the Forwarding Information Base
show ip route
(FIB).
S
YNTAX
show ip route [connected | database | static | summary]
C
OMMAND
Privileged Exec
C
OMMAND
◆ The FIB contains information required to forward IP traffic. It contains
the interface identifier and next hop information for each reachable
S
ETTING
M
ODE
U
SAGE
connected – Displays all currently connected entries.
database – All known routes, including inactive routes.
static – Displays all static entries.
summary – Displays a brief list of summary information about
entries in the routing table, including the maximum number of
entries supported, the number of connected routes, the total
number of routes currently stored in the routing table, and the
number of entries in the FIB.
M
ODE
U
SAGE
– 1469 –
| IP Routing Commands
C 46
HAPTER
IPv4 Commands