Edge-Core ECS4110-28T Management Manual page 1424

| IP Interface Commands
C 46
HAPTER
IPv4 Interface
ip default-gateway
This example assigns an IP address to VLAN 2 using a classless network
mask.
Console(config)#interface vlan 2
Console(config-if)#ip address 10.2.2.1/24
Console(config-if)#
R C
ELATED OMMANDS
ip dhcp restart client (1413)
ip default-gateway (1424)
ipv6 address (1434)
This command specifies the default gateway for destinations not found in
local routing tables. Use the no form to remove a default gateway.
S
YNTAX
ip default-gateway gateway
no ip default-gateway
gateway - IP address of the default gateway
D S
EFAULT ETTING
No default gateway is established.
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
◆ The default gateway can also be defined using the following Global
configuration command: ip route 0.0.0.0 0.0.0.0 gateway-address.
Static routes can also be defined using the
◆
that traffic to the designated address or subnet passes through a
preferred gateway.
A default gateway can only be successfully set when a network
◆
interface that directly connects to the gateway has been configured on
the router.
The same link-local address may be used by different interfaces/nodes
◆
in different zones (RFC 4007). Therefore, when specifying a link-local
address for a default gateway, include zone-id information indicating
the VLAN identifier after the % delimiter. For example, FE80::7272%1
identifies VLAN 1 as the interface.
– 1424 –
ip route command to ensure