Edge-Core ECS4110-28T Management Manual page 1399

This command displays the results of an OAM remote loopback test.
show efm oam
remote-loopback
interface S
YNTAX
C
OMMAND
Normal Exec, Privileged Exec
E
XAMPLE
Console#show efm oam remote-loopback interface 1/1
Port OAM loopback Tx OAM loopback Rx Loss Rate
---- --------------- --------------- ---------
1/1
Console#
This command displays OAM configuration settings and event counters.
show efm oam
status interface
S
YNTAX
C
OMMAND
Normal Exec, Privileged Exec
E
XAMPLE
Console#show efm oam status interface 1/1
OAM information of Eth 1/1:
show efm oam remote-loopback interface [interface-list]
interface-list - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate
nonconsecutive port identifiers with a comma and no spaces;
use a hyphen to designate a range of ports. (Range: 1-28/52)
M
ODE
10000
show efm oam status interface [interface-list] [brief]
interface - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate
nonconsecutive port identifiers with a comma and no spaces;
use a hyphen to designate a range of ports. (Range: 1-28/52)
brief - Displays a brief list of OAM configuration states.
M
ODE
Basic Information:
Admin State
Operation State
Mode
Remote Loopback
Remote Loopback Status
Dying Gasp
Critical Event
Link Monitor (Errored Frame)
– 1399 –
C 43
HAPTER
9999 0.01 %
: Enabled
: Operational
: Active
: Disabled
: No loopback
: Enabled
: Enabled
: Enabled
| OAM Commands