Edge-Core ECS4110-28T Management Manual page 1453

E
The following configures five neighbor solicitation attempts for addresses
configured on VLAN 1. The
duplicate address detection process is still on-going.
R
ipv6 nd ns-interval (1453)
show ipv6 neighbors (1457)
This command configures the interval between transmitting IPv6 neighbor
ipv6 nd ns-interval
solicitation messages on an interface. Use the no form to restore the
default value.
S
D
1000 milliseconds is used for neighbor discovery operations
0 milliseconds is advertised in router advertisements
C
Interface Configuration (VLAN)
XAMPLE
Console(config)#interface vlan 1
Console(config-if)#ipv6 nd dad attempts 5
Console(config-if)#end
Console#show ipv6 interface
VLAN 1 is up
IPv6 is enabled
Link-local address:
fe80::200:e8ff:fe90:0/64
Global unicast address(es):
2009:db9:2229::79, subnet is 2009:db9:2229:0::/64
Joined group address(es):
ff01::1/16
ff02::1/16
ff02::1:ff00:79/104
ff02::1:ff90:0/104
IPv6 link MTU is 1500 bytes.
ND DAD is enabled, number of DAD attempts: 5.
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised router lifetime is 1800 seconds
Console#
C
ELATED OMMANDS
YNTAX
ipv6 nd ns-interval milliseconds
no ipv6 nd ns-interval
milliseconds - The interval between transmitting IPv6 neighbor
solicitation messages. (Range: 1000-3600000)
S
EFAULT ETTING
M
OMMAND ODE
– 1453 –
C 46
HAPTER
show ipv6 interface command indicates that the
| IP Interface Commands
Neighbor Discovery