Interface; Table 4-2 Interface Commands - Edge-Core ES4524M-PoE Management Manual

Interface Commands
These commands are used to display or set communication parameters for an
Ethernet port, aggregated link, or VLAN.
Command

interface

description
speed-duplex
negotiation
capabilities
flowcontrol
media-type
shutdown
switchport packet-rate Configures broadcast and multicast and unknown unicast storm
clear counters
show interfaces status Displays status for the specified interface
show interfaces
counters
show interfaces
switchport
interface
This command configures an interface type and enter interface configuration mode.
Use the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
interface
• ethernet unit/port
- unit - Stack unit. (Always unit 1)
- port - Port number. (Range: 1-24)
• port-channel channel-id (Range: 1-8)
• vlan vlan-id (Range: 1-4093)
Default Setting
None

Table 4-2 Interface Commands

Function
Configures an interface type and enters interface configuration
mode
Adds a description to an interface configuration
Configures the speed and duplex operation of a given interface
when autonegotiation is disabled
Enables autonegotiation of a given interface
Advertises the capabilities of a given interface for use in
autonegotiation
Enables flow control on a given interface
Force port type selected for combination ports
Disables an interface
control thresholds
Clears statistics on an interface
Displays statistics for the specified interfaces
Displays the administrative and operational status of an
interface
Interface Commands
Mode Page
GC 4-135
IC 4-136
IC 4-136
IC 4-137
IC 4-138
IC 4-139
IC 4-140
IC 4-141
IC 4-141
PE 4-142
NE, PE 4-143
NE, PE 4-144
NE, PE 4-145
4-135
4