Interface Commands; Table 69: Interface Commands - Edge-Core ECS2100-10T Reference Manual

11

Interface Commands

These commands are used to display or set communication parameters for an
Ethernet port, aggregated link, or VLAN; or perform cable diagnostics on the
specified interface.

Table 69: Interface Commands

Command
Interface Configuration
interface
capabilities
description
flowcontrol
history
media-type
negotiation
shutdown
speed-duplex
clear counters
show interfaces brief
show interfaces counters
show interfaces history
show interfaces status
show interfaces switchport
Transceiver Threshold Configuration
transceiver-monitor
transceiver-threshold-auto
Function
Configures an interface type and enters interface
configuration mode
Advertises the capabilities of a given interface for use in
autonegotiation
Adds a description to an interface configuration
Enables flow control on a given interface
Configures a periodic sampling of statistics, specifying the
sampling interval and number of samples
Forces transceiver mode to use for SFP/SFP+ ports, or the
port type to use for combination RJ-45/SFP ports
Enables autonegotiation of a given interface
Disables an interface
Configures the speed and duplex operation of a given
interface when autonegotiation is disabled
Clears statistics on an interface
Displays a summary of key information, including
operational status, native VLAN ID, default priority, speed/
duplex mode, and port type
Displays statistics for the specified interfaces
Displays periodic sampling of statistics, including the
sampling interval, number of samples, and counter values
Displays status for the specified interface
Displays the administrative and operational status of an
interface
Sends a trap when any of the transceiver's operational
values fall outside specified thresholds
Uses default threshold settings obtained from the
transceiver to determine when an alarm or trap message
should be sent
– 349 –
Mode
GC
IC
IC
IC
IC
IC
IC
IC
IC
PE
PE
NE, PE
NE, PE
NE, PE
NE, PE
IC
IC