Inspect 1St Gear Thrust Clearance - Toyota Celica 2000 Repair Manual

MX-42
•••
•
Mi d dl e
R1ng
- �Tf --------
MANUAL TAANSAXLE
HINT:
Take care not to damage the journal surface of the output shaft.

INSPECT 1ST GEAR THRUST CLEARANCE

6.
(See page MX-35)
INSTALL SPACER, NEEDLE ROLLER BEARING,
7.
For 2nd Gear
NO. 2 SYNCHRONIZER RING, 2ND GEAR AND 3RD
DRIVEN GEAR
Install the spacer.
(a)
Apply gear oi! to the needle roller bearing and install it.
(b)
Place the No. 2 synchronizer rings on the 2nd gear.
(c)
NOTICE: •
Properly fit the synchronizer middle ring claws into
D07361
•
the holes in the 2nd gear.
Distinguish the No. 2 synchronizer ring by the teeth
on the synchronizer ring.
(d) Place the 2nd gear with the No. 2 synchronizer rings and
Synchronizer
Inner Ring
allgn the No. 2 synchronizer ring slots with the No. 1 shift­
ing keys.
NOTICE:
Fit the synchronizer inner ring claws Into the slots in the
No. 1 clutch hub.
007362
Using a press, install the 3rd driven gear.
(e)
NOTICE:
Be sure to install the 3rd driven gear In the correct direc�
tion, as shown in the illustration.
INSPECT 2ND GEAR THRUST CLEARANCE
8.
(See page MX-35)
fJOJ36J
OUTPUT SHAFT