Center Spiral Cable; Install Steering Wheel; Install Steering Wheel Pad - Toyota Celica 2000 Repair Manual

N
�
STEERING
TILT STEERING COLUMN
14.

CENTER SPIRAL CABLE

(a) Check that the front wheels are facing straight ahead.
Turn the cable counterclockwise by hand until it becomes
(b )
harder to turn.
Then rotate the cable clockwise about 2.5 turns to align
{c)
the marks.
HINT:
The cable will rotate about 2.5 turns to either left or right of the
center.

INSTALL STEERING WHEEL

15.
Align the matchmarks on the steering wheel and main
(a)
shaft assembl y.
Install the steering wheel set nut.
(b)
34
.
Torque: N m (350 kgf. cm, 25 fl·lbl)
(c) Connect the connector.
16.

INSTALL STEERING WHEEL PAD

•
NOTICE:
Never use airbag parts from another vehicle. When
replacing parts, replace with new ones.
Make sure the wheel pad Is Installed with the speci�
fied torque.
•
If the wheel pad has been dropped, o r there are
cracks, dents or other defects in the case or connec­
tor, replace the wheel pad with a new one.
•
When installing the wheel pad, take care that the wir­
ings do not interfere with other parts and that they are
not pinched between other parts.
Connect the airbag connector.
(a)
(b) Install the steering wheel pad after confirming that the cir­
cumference groove of the torx screws is caught on the
screw case.
(c) Using a torx socket wrench, torque the 2 screws.
·
m (90 kgf . cm, 78 in. . lbl)
Torque: 8.8 N
CHECK STEERING WHEEL CENTER POINT
17.
SA-21