Toyota Celica 2000 Repair Manual page 407

MX--<;
MANUAL TRANSAXLE
Attach the engine chain hoist to the engine hangers.
(c)
CAUTION:
Do not attempt to hang the engine by hooking the chain to
any other part.
REMOVE ENGINE LEFT MOUNTING BRACKET 3 SET
14 .
BOLTS AND NUT
Torque:
Bolt A: 60 N-m (610 kgl-cm, 44 ft-lbl)
Nut B: 80 N-m (820 kgl-cm, 59 ft-lbl)
REMOVE ENGINE LEFT MOUNTING BRACKET
15.
Lower the transaxle side, and remove the bolt and engine left
mounting bracket.
Torque: 60 N-m (610 kgl-cm, 44 ft-lbl)
16. RAISE VEHICLE
CAUTION:
Make sure that the vehicle is securely supported.
17. REMOVE CENTER, LH AND RH ENGINE UNDER COV­
ERS
DRAIN TRANSAXLE OIL
18.
011 grade: API GL-4 or GL-5
Viscosity: SAE 75W-90
Capacity: 2.3 liters (2.4 US qts, 2.0 Imp. qts)
Torque: 39 N-m (400 kgf.cm, 29 ft-lbl)
19 . REMOVE LH AND RH FRONT DRIVE SHAFTS
(See page SA-18)
REMOVE FRONT EXHAUST PIPE
20.
Disconnect the 2 heated oxygen sensors.
(a)
Torque: 44 N-m (450 kgf-cm, 33 ft-lbl)
HINT:
At the time of installation, please refer to the following items.
•
Before installing the heated oxygen sensor, twist the sen�
sor wire counterclockwise 3 and 1/2 turns.
After insta\hng the heated oxygen sensor, check that the
sensor wire is not twisted. !f it is twisted, remove the
heated oxygen sensor and reinstall i!.
{ b) Remove the 4 bolts, compression springs and 2 gaskets.
Torque: 43 N.m (440 kgf.cm, 32 ft·lbf)
MAN UAL-� RANSAXLl' UN!T