Power Steering Vane Pump Installation; Install Ps Vane Pump Assembly; Connect Pressure Feed Tube; Install Drive Belt - Toyota Celica 2000 Repair Manual

SR-32
-
POWEn STEERING VANE PUMP
STEERING
INSTALLATION

INSTALL PS VANE PUMP ASSEMBLY

1 .
Install the PS vane pump assembly with the 2 pump assembly
set bolts and nuts.
Torque: 37 N·m (370 kgf.cm, 27 ft.lbl)
2. CONNECT OIL PRESSURE SWITCH CONNECTOR
NOTICE:
Be careful to prevent oil from being attached to the connecM
tor.

CONNECT PRESSURE FEED TUBE

3.
Connect the pressure feed tube clamp with the bolt.
(a)
Torque: 7.8 N.m (80 kgf.cm, 69 ln .. lbl)
Using SST, connect the pressure feed tube.
{b)
SST 09631�22020
Torque: 37 N.m (375 kgf.cm, 27 ft.lbl)
HINT:
Use a torque wrench with a fulcrum length of 345 mm
( 1 1 .81 in).
•
This torque value is effective in case that SST is parallel
to a torque wrench.
CONNECT SUCTION HOSE
4.
Connect the suction hose with the clip.
5.

INSTALL DRIVE BELT

Loosen the drive belt tension by turning the drive belt tensioner
arm clockwise, and install the drive belt
INSTALL RH AND CENTER ENGINE UNDER COVERS
6.
7. BLEED POWER STEERING SYSTEM
(See page SR-4)