Install Ventilation Case; Install Water Bypass Pipe; Install Oil Dipstick And Guide; Install Flywheel - Toyota Celica 2000 Repair Manual

ENGINE MECHANICAL CYLINDER BLOCK
24. 2ZZ-GE:

INSTALL VENTILATION CASE

Install a new gasket and ventilation case with the 3 bolts.
(a )
Torque: 8.5 N-m (87 kgf . cm, 75 in.-lbf)
Install the No. 3 ventilation hose and connect the clip.
(b )
25. INSTALL THERMOSTAT (See page C0-11)
26.

INSTALL WATER BYPASS PIPE

Torque:
1ZZ-FE 9.0 N-m (92 kgf.cm, 80 in.-lbf)
2ZZ-GE
Bolt 8.5 N-m (87 kgf.cm, 75 ln.-lbf)
Nut 10 N-m (100 kgf-cm, 7 ft-lbf)
27. 1ZZ-FE:

INSTALL OIL DIPSTICK AND GUIDE

Install a new 0-rlng on the dipstick guide.
(a)
Apply soapy water on the 0-ring.
(b)
Connect the dipstick guide end to the main bearing cap.
{c)
Install the dipstick guide wlth the bolt.
(d)
Torque: 11 N-m (113 kgf-cm, 8 ft-lbf)
28.
INSTALL CYLINDER HEAD (See page EM-65)
29. INSTALL ENGINE WIRE
30. INSTALL TIMING SPROCKETS AND TIMING CHAIN
(See page EM-25)
31. REMOVE ENGINE STAND
32. M!T:

INSTALL FLYWHEEL

HINT:
The flywheel bolts are tightened in 2 progressive steps, (a) and
(c).
Install and uniformly tighten the 8 mounting bolts, in sev­
(a)
eral passes, in the sequence shown.
Torque: 49 N-m (500 kgf-cm, 36 ft-lbf)
Mark the flywheel bolt with paint.
(b)
Retighten the flywheel bolts by an additional 90�.
(c)
Check that the painted mark in now at a 90" angle to (b).
(d )
EM-- 1 13