Install Check Valve And Spring; Install Valve Body; Install Atf Temperature Sensor - Toyota Celica 2000 Repair Manual

AUTOMATIC TAANSAXLE (U341E)
Cover
p
VALVE BODY ASSEMBL Y

INSTALL CHECK VALVE AND SPRING

14.
15.

INSTALL VALVE BODY

Align the groove of the manual valve with the pin of the
(a)
manual valve lever.
Temporarily install the valve body with the 1 2 bolts.
(b)
Bolt length:
Bolt A: 55 mm (2.17 1n.)
Bolt B: 45 mm (1.77 in.)
Bolt C : 32 mm (1.26 in.)
Bolt D : 22 mm (0.87 in.)
Temporarily install the detent spring and cover with the 3
{c)
bolts.
Bolt length:
Bolt B: 45 mm (1.77 1n.)
Bolt C: 32 mm (1.26 in.)
Bolt E: 14 mm (0.55 in.)
Check that the manual valve lever contacts the center ot
(d)
the roller at the tip of the detent spring.
Tighten the 1 5 bolts.
(e)
Torque: 1 1 N.m (110 kgf . cm, 8 ft.lbf)
16.

INSTALL ATF TEMPERATURE SENSOR

Instal! the ATF temperature sensor with the lock plate and bolt.
Torque: 10 N . m (100 kgf . cm, 8 ft·lbl)
17. CONNECT 5 SHIFT SOLENOID VALVE CONNECTORS
18. INSTALL OIL STRAINER
Coat a new 0-ring with ATF.
(a)
Instal! the Q-ring to the oil strainer.
(b)
005$)4
AX-1 1