Toyota Celica 2000 Repair Manual page 444

N
N
MANUAL TRANSAXLE
REASSEMBLY
HINT:
Coat all of the sliding and rotating surfaces wlth gear oil before
reassembly.
1.
Using SST and a press, install the front bearing inner race.
NOTICE:
Be sure to Install the front bearing inner race in the correct
direction, as shown i n the Illustration.
2.
(a)
Mark
7
8
1
'
(b)
HINT:
Take care not to damage the journal surface of the output shaft.
3.
Pr e ss
(a)
(b)
..
NOTIC E:
Assemble the No. 1 clutch hub and reverse gear in the
direction shown in the illustration.
-
SHAH
OUTPUT
INSTALL FRONT BEARING INNER RACE
SST 09223-5001 0
INSTALL SNAP RING
Select a snap ring from the table below that wH! make the
thrust clearance of the front bearing inner race less than
0 . 1 mm (0.0039 in.).
Th1cknoss mm(l11)
1.85 (0.0728)
{0.0748)
1 90
1.95 (0.07il8)
2.00 (0.0787)
Usmg a screwdnver and hammer, tap m the snap nng.
ASSEMBLE REVERSE GEAR ASSEMBLY
Instal! the 3 No. 1 shifting key springs and No. 1 shifting
keys to the No. 1 clutch hub.
Install the No. 1 clutch hub to the reverse gear.
MX-43
MM< Thfclc.ness mm {in.)
3 (0.0807)
2.05
4 2.10 (0.0827]
2 15
5
(0 0846)
6
(0.0866)
2.20