Toyota Celica 2000 Repair Manual page 24

�
ENGINE MECHANICAl
TIMING CHAIN
(d) Remove the
cover and gasket.
9. 2ZZ-GE:
REMOVE CYLINDER HEAD COVER
Remove the
(a)
Remove the ignition coils (See page IG-6).
(b)
Disconnect the 2 PCV hoses from the cylinder head cov­
(c)
er.
(d ) Remove the 2 nuts, bolt and disconnect the No. 3 ventila­
tion hose from the No. 1 ventilation pipe.
Remove the No.
(e)
Remove the
(f)
cover and gasket.
Remove the Q-.ring from tho cylinder head cover.
(g)
10. SET NO. 1 CYLINDER TO TDC/COMPRESSION
Turn the crankshaft pulley, and align its groove with timing
(a)
�o�
mark
(b) Check that the point marks of the camshaft timing sprock­
ets are in straight line on the liming chain cover surface
I f not, turn the crankshaft
as shown in the illustration.
marks as above.
bolts, 2 seal washers, 2 nuts, cylinder head
9
bolts and No. 2 cylinder head cover.
4
ventilation pipe and gasket.
1
bolts, wire harness protector, cylinder head
9
of the timing chain cover.
revolution (360°) and align the
1
EM -1 9