Inspect Wireless Door Lock Control Receiver Circuit - Toyota Celica 2000 Repair Manual

Wire harness side:
N
Tesler connection
1 - Ground
5 - Ground
-
BODY ELECTRICAL
WIRELESS
HINT:
•
When the temperature of the battery is low, the judge can
not be made correctly.
When the outcome of the test is less than 2.1 V, conduct
the test again after leaving the battery in the place at 1 8
4C for more than 3 0 minutes.
By auto power off function, the voltage becomes no load
voltage (more than 2.5 V) condition atter20 seconds from
the switch was pressed.
Make sure to read the voltage before of it.
High voltage might be shown 1 to 2 times after leaving the
battery, judge should be made with the voltage shown at
the 3rd time or later.
( g) Disconnect the lead.
(h ) Set the battery (lithium battery) in the transmitter.
Install the cover, so that the 0-- r ing is not distorted or
(i)
(j)
slipped off.
Using a screwdriver, tighten the screw.
3. INSPECT WIRELESS DOOR LOCK CONTROL RE·
CEIVER CIRCUIT
Disconnect the connector from the receiver and inspect
(a)
the connector on the wire harness side, as shown below.
Co nell ! ion
Cons!ant
Constant
If the ctrcutt
IS
other parts.
OOOR LOCK CONTROL SYSTEM
SpeCified condition
Conlinuity
8aUery voHage
"
not as spectfted, tnspect the ctrcutt connected to
BE-75