Toyota Celica 2000 Repair Manual page 724

STEERING
ATTACH ENGINE SLING DEVICE TO ENGINE HANG-
11.
No. 2
Engine
ERS
Hanger
(a } Remove the 4 bolts and No. 2 cylinder head cover_
Disconnect the PCV hoses from the cylinder head cover.
(b)
Install the No. 1 and No. 2 engine hangers in the correct
(c)
direction.
1ZZ-FE Engine:
Part No.:
No. 1 engine hanger: 12261-22021
No. 2 engine hanger: 12281-15040 or 1 2281-15050
Boll: 91512-B1016
Torque: 38 N-m (388 kgf-cm, 28 ft-lbf)
2ZZ-FE Engine:
Part No.:
No. 1 engine hanger: 1 2281--88 6 00
No . 2 engine hanger: 1 2282-88600
Bolt: 91512-61020
Torque: 38 N-m (388 kgf.cm, 28 ft-lbf)
(d) Attach the engine sling device to the engine hangers.
CAUTION:
Do not attempt to hang the engine by hooking the chain to
any other part.
12. DISCONNECT LOWER BALL JOINT FROM LOWER
SUSPENSION ARM (See page SA-42)
13. DISCONNECT STABILIZER BAR
(a) Remove the nut and disconnect the stabilizer bar.
(b) Employ the same manner described above to the other
side.
14 . DISCONNECT ENGINE REAR MOUNT INSULATOR
AND FRONT SUSPENSION MEMBER
Remove the bolt (bolt A} and 3 nuts, and disconnect the engine
rear mount insulator and front suspension member.
15. DISCONNECT ENGINE FRONT MOUNT INSULATOR
AND FRONT SUSPENSION MEMBER
Remove the 2 bolts (bolt B) and disconnect the engine front
mount insulator and front suspension member.
16. SUPPORT FRONT SUSPENSION MEMBER WITH
LOWER SUSPENSION ARM
Using a transmission jack, support the front suspension mem­
ber with tower suspension arm.
17. REMOVE FRONT SUSPENSION MEMBER WITH LOW-
ER SUSPENSION ARM AND PS GEAR ASSEMBLY
Remove the 6 bolts (bolt C, D and E) and front suspension
member with lower suspension arm and PS gear assembly.
18.
REMOVE PS GEAR ASSEMBLY
Remove the 4 bolts and PS gear 3ssembly from the front
(a)
suspension member.
�
POWER SIEEF�JNG GEAR
SR-37