Remove Rear Bearing Retainer; Remove Bearing Snap Ring; Remove Lock Ball Assembly - Toyota Celica 2000 Repair Manual

-
MANUAL TRANSAXLE(C56)
17.

REMOVE REAR BEARING RETAINER

Remove the 5 bolts and rear bearing retainer.
Sealant:
Part No. 0883:Hl0080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 27 N. m (280 kgf.cm, 20 ft.Jbf)

REMOVE BEARING SNAP RING

18.
Using a snap ring expander, remove the 2 snap rings.
HINT:
If it is difficult to remove and instal! the snap rings, pull up the
shafts.
19. REMOVE REVERSE IDLER GEAR SHAFT LOCK BOLT
AND GASKET
Sealant:
Part No. 0883:Hl0080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 29 N·m (300 kgf.cm, 22 ft·lbf)
20. REMOVE SNAP RING FROM NO. 2 SHIFT FORK
SHAFT
Using 2 screwdrivers and a hammer, tap out the snap ring.
21. REMOVE STRAIGHT SCREW PLUG, SEAT, SPRING
AND BALL
Using a hexagon wrench, remove the 3 straight screw
(a)
plugs.
Sealant:
Part No. 0883:Hl0080, THREE BOND 1 344, LOCTITE
242 or equivalent
Torque: 25 N·m (250 kgf . cm, 18 ft·lbf)
Using a magnetic finger, remove the 3 seats, springs and
(b)
balls.
22.

REMOVE LOCK BALL ASSEMBLY

Using a hexagon wrench, remove the lock ball assembly.
Sealant:
Part No. 0883:Hl0080, THREE BOND 1 344, LOCTITE
242 or equivalent
Torque: 39 N·m (400 kgf.cm, 29 ft·lbf)
MANUAL TRANSAXLEASSEMBLY
MX-17