Toyota Celica 2000 Repair Manual page 364

MANUAL TRANSAXLE
Mark 00 / 3 3 6
Align Alignment
MANUAL TRI\NSAXLE ASSEMBLY
•
Install the reverse Idler gear, thrust washer and shaft,
as shown in the illustration.
27 . REMOVE GEAR SHIFT FORK AND GEAR SHIFT FORK
SHAFT
Using 2 screwdrivers and a hammer, tap out the 3 snap
(a)
rings from each gear shift fork shaft.
Remove the 3 bo!ts from the No.
(b)
and No. 2 gear shift forks.
Sealant:
Part No. 08833-00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 16 N·m (160 kgf.cm, 1 2 ft·lbf)
Pull up the No. 3 gear shift fork shaft, remove the No. 2
(c)
gear shift fork shaft.
NOTICE:
At the time of reassembly, please refer to the following
item.
To avoid the interference of the 2 balls, lift up the No. 3 gear
shift fork shaft at the position shown in the illustration.
Remove the No. 1 gear shift head.
(d)
MX-19
gear shift head, No. 1
1