Remove Front Door Weatherstrip; Remove Front Door Belt Moulding - Toyota Celica 2000 Repair Manual

Butyl
/:.:
l
i
1 4 C ps
T
BODY
•
7.
8.
9.
NOTICE:
Do not tear the cover.
HINT:
10.
Tape
(a)
HINT:
Tape the screwdriver tip before use.
(b)
HINT:
T ape the screwdriver tip before use.
1 1 .
(a)
(b)
-
FRONT DOOR
The sensor is equipped with an electrical connection
check mechanism. Be sure to lock this mechanism
securely when connecting the connector. If not, a
malfunction code may be detected by the diagnostic
system.
Torque: 8.3 N·m (85 kgf.cm, 74 in .
REMOVE OUTSIDE REAR VIEW MIRROR
wl Tweeter speaker:
REMOVE TWEETER SPEAKER
REMOVE SERVICE HOLE COVER
At the time of reassembly, please refer to the following
item.
Bring out the 2 cables and wire harness through the slits
of service hole cover.

REMOVE FRONT DOOR WEATHERSTRIP

Using a clip remover, remove the 4 clips.
Using a clip remover, remove the front door weatherstrip.

REMOVE FRONT DOOR BELT MOULDING

Remove the screw.
Using a moulding remover, remove the front door belt
moulding.
B0-13
.
fbf)