Toyota Celica 2000 Repair Manual page 616

N
SUSPENSION AND AXlE
(c) Remove the nut, cam plate and cam bolt.
Torque: 74 N·m (755 kgf.cm, 55 ft.lbf)
HINT:
At the time of installation, after stabilizing the suspension,
torque the nut.
Disconnect the rear axle carrier from the lower suspen­
{d)
sion arm.
7. DISCONNECT REAR SHOCK ABSORBER
Remove the bolt and nut and disconnect the rear shock absorb-
CL
Torque: 140 N·m (1,428 kgf.cm, 103 ft·lbf)
NOTICE:
Do not turn the nut.
HINT:
At the time of installation, after stabilizing the suspension,
torque the bolt.
8. REMOVE LOWER SUSPENSION ARM
Remove the bolt and nut on the rear side of lower suspen­
(a)
sion arm.
Torque: 74 N.m (755 kgf.cm, 55 ft·lbf)
HINT:
At the time of installation, after stabilizing the suspension,
torque the nut.
(b) Remove the front side 3 bolts and lower suspension arm.
9. REMOVE SUSPENSION ARM BRACKET
Remove the nut, suspension arm bracket and stopper.
Torque: 1 1 0 N.m (1 ,122 kgf.cm, 81 ft.lbf)
HINT:
At the lime of installation, after stabilizing the suspension,
torque the nut.
REAR LOWER SUSPENSION ARM
SA-73