Toyota Celica 2000 Repair Manual page 778

SUPPLEMENTAL RESTRAINT SYSTEM
St r i p ped
Wire Harness
p
Di a met e r
(b)
Wire Harness
CAUTION:
If the front passenger airbag assembly is tied down with
S
too thin wire harness, it may snap. This is highly dangerM
ous. Always use a wire harness which is at least 1.25 mm 2
AUOIGJ
i on
ect
(0.0019 in 2 .).
HINT .
To calculate the square of the stripped wire harness section:
Ht1961
(3)
Tire size: Must exceed the following dimensions­
Width: 185 mm (7.28 in.)
Inner diameter: 360 mm (14.17 in.)
f
-
PASSENGER AIRBAG ASSEMBLY
FRQN
Using a service-purpose wire harness, tie down the front
passenger airbag assembly to the tire.
Wire harness: Stripped wire harness section
1.25 mm 2 or more (0.0019 in. 2 or more)
=
3.14 X (Diameter) ' divided by 4
Square
( 1 ) Install the 2 nuts on the front passenger airbag as­
sembly.
Wind the wire harness around the bolts, and pass
(2)
the wire harness though the installation holes.
Position the front passenger airbag assembly in�
side the tire with the airbag deployment side facing
inside.
RS-33