Toyota Celica 2000 Repair Manual page 440

MANUAL TRANSAXLE (C60)
--- -
--
----- -
- ---�� - - - -------
-
OUTPUT SHAFT
REMOVE 3RD DRIVEN GEAR, 2ND GEAR, NEEDLE
4,
ROLLER BEARING, SPACER AND NO. 2 SYNCHRO­
NIZER RING
Shift the reverse gear into the 1st gear.
(a)
Using SST and a press, remove the 3rd driven gear and
(b)
2nd gear.
SST 0995Q-- 0 0020
HINT:
Support the output shaft assembly by hand so that it wiJJ not be
dropped off.
Remove the needle roller bearing, spacer and No. 2 syn-
{c)
chronizer rings.
5. REMOVE SNAP RING
Using 2 screwdrivers and a hammer, tap out the snap ring.
HINT:
Take care not to damage the journal surface of the output shaft.
REMOVE REVERSE GEAR ASSEMBLY, 1 ST GEAR,
6.
NO. 1 SYNCHRONIZER RING, NEEDLE ROLLER
BEARING, 1ST GEAR THRUST WASHER AND BALL
Using a press, remove the reverse gear assembly, 1 st
(a)
gear and No. 1 synchronizer ring.
HINT:
Support the output shaft assembly by hand so that it will not be
dropped off.
00 0343
Remove the needle ro!ler bearing and i st gear thrust
(b)
washer.
Using a magnetic finger, remove the ball.
(c)
REMOVE SNAP RING
7.
Using 2 screwdrivers and a hammer, tap out the snap ring.
HINT:
Take care not to damage the journal surface of the output shaft.
MX-39