Toyota Celica 2000 Repair Manual page 565

SA-22
Matchmarks
SUSPENSION AND AXLE
DISASSEMB LY
1.
(a}
h'()( l\91
(b)
(c)
Remove the inboard joint shaft.
{d)
( 1 )
--j
r-- - ---
(2)
NOTICE:
Do not punch the marks.
f0-4011
(3 }
(4 )
F01012
-
FRONT DRIVE SHAFT
1ZZ-FE engine (Mff) and 2ZZ-GE engine:
DISASSEMBLE DRIVE SHAFT
Check the drive shaft.
Check to see that there is no remarkable play in the
( 1 )
outboard joint.
Check to see that the inboard joint slides smoothly
( 2 )
in the thrust direction.
Check to see that there is no remarkable play in the
(3)
radial direction of the inboard joint.
Check the boots for damage.
(4)
Remove the inboard and outboard joint boot clamps.
Using a screwdriver, disclamp the 2 inboard joint
( 1 )
boot clamps.
Using a side cutter, cut the 2 outboard joint boot
{2)
clamps and remove them.
MIT:
Remove the dynamic damper clamp.
Using a screwdriver, disclamp the dynamic damper
clamp.
Slide the inboard joint boot toward the outboard
joint.
Place matchmarks on the outboard joint shaft and
inboard joint shaft.
Using a screwdriver, remove the snap ring.
Remove the inboard joint shaft from the outboard
joint shaft.