Connect Tube Clamp; Connect Pressure Feed And Return Tubes - Toyota Celica 2000 Repair Manual

SR-52
- - - -- --- �
STEERING
j
DISENGAGE ENGINE SLING DEVICE FROM ENGINE
8.
No. 2 Engine
HANGERS
Hanger
Disengage the engine sling device from the engine hang�
(a)
ers.
Remove 1t1e No. 1 and No. 2 engine hangers.
(b)
Connect the PCV hoses to the cylinder head cover.
(c)
Install the No. 2 cylinder head cover with the 4 bolts.
(d)
9. INSTALL ENGINE HOOD (See page B0-9)
CONNECT COLUMN HOLE COVER SUB-ASSEMBLY
10.
At( '4J4
1 1 .

CONNECT TUBE CLAMP

Connect the tube clamp with the boll.
Torque: 7.8 N-m (80 kgf-cm, 69 in.·lbf)
12.

CONNECT PRESSURE FEED AND RETURN TUBES

Using SST, connect the pressure feed and return tubes.
SST
Torque: 37 N-m (375 kgf-cm, 27 ft.Jbf)
HINT:
Use a torque wrench with a fulcrum length of 345 mm
(13 . 58 in.).
•
This torque value is effective in case that SST is parallel
to a torque wrench.
13. CONNECT NO. 2 INTERMEDIATE SHAFT ASSEMBLY
(See page SR-19)
14. CONNECT RH AND LH TIE ROD ENDS
(See page SA-16)
15. INSTALL RH, CENTER AND LH ENGINE UNDER COV-
ERS
16. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
HINT:
Do it with the front of the vehicle jacked up.
17. CENTER SPIRAL CABLE (See page SR-19)
18. INSTALL STEERING WHEEL
Align the match marks on the steering wheel and steering
(a)
column main shaft.
Temporarily tighten the steering wheel set nut.
(b)
19. BLEED POWER STEERING SYSTEM
(See page SR-4)
-
POWER STEERING GEAI1
09631-22020