Disconnect Speed Sensor Connector; Remove Speed Sensor - Toyota Celica 2000 Repair Manual

BR-56
N
BRAKE
t-HQNT SPF.I-:0 SENSOR
REMOVAL

DISCONNECT SPEED SENSOR CONNECTOR

1.
Remove the front wheel.
(a)
Torque: 103 N·m ( 1,050 kgf.cm, 76 fl·lbf)
(b) Remove the fender liner.
Disconnect the speed sensor connector and resin clip.
(c )

REMOVE SPEED SENSOR

2.
Remove the 2 clamp bolts holding the sensor harness
(a)
from the body and shock absorber.
Torque: 8.0 N-m (82 kgf-cm, 71 in..lbf)
Remove the speed sensor installation bolt from the steer­
(b)
ing knuckle.
Torque: 8.0 N-m {82 kgf-cm, 71 in.-lbf)
NOTICE:
At the time of installation, please refer to the following item.
•
There are no foreign objects on the sensor or the part
of the knuckle to which the sensor is to be installed.
•
The sensor Is installed flat against the knuckle when
you tighten the bolt.