Disassemble Inboard Joint Shaft - Toyota Celica 2000 Repair Manual

SA-24
SUSPENSION AND AXLE FflON f
Place match marks on the inboard joint shaft, tripod
(2)
and outboard joint shaft.
NOTICE:
Do not punch the marks.
Remove the inboard joint shaft from the outboard
(3)
joint shaft.
(d) Remove the tripod.
{ 1 ) Using a snap ring expander, remove the snap ring.
Place matchmarks on the outboard joint shaft and
{2)
tripod.
NOTICE:
Do not punch the marks.
Using a brass bar and hammer, remove the tripod
(3)
from the outboard joint shaft
NOTICE:
Do not tap the roller.
Rem o ve the inboard and outboard joint boots and in­
(e)
board joint clamps.
NOTICE:
Do not disassemble the out board joint.
3.

DISASSEMBLE INBOARD JOINT SHAFT

LH:
(a)
Remove the dust cover.
Using SST and a press, remove the dust cover.
SST
LH shaft of 1 ZZ-FE engine (Mrf) and 2ZZ--GE engine:
(b)
Using a snap ring expander, remove the outer snap ring_
H09716
(c) RH:
Remove the transax!e side dust cover.
Using a press, remove the transax!e side dust cover.
DRIVE SHAF' f
0995G-00020