Toyota Celica 2000 Repair Manual page 443

MX-42
-
MANUAL TRANSAXLE;
3. INSPECT GEAR SHIFT FORK A N D REVERSE GEAR
CLEARANCE
Using a feeler gauge, measure the clearance between the re­
verse gear and gear shift fork.
Maximum clearance: 0.35 mm (0.014 in.)
If the clearance exceeds the maximum, replace the gear shift
fork or hub sleeve.
INSPECT OUTPUT SHAFT
4.
Check the output shaft for wear or damage.
(a)
Using a micrometer, measure the outer diameter of the
(b)
output shaft journal surface.
Minimum outer diameter:
Part A: 32.985 mm (1.2986 ln.)
Part B: 37.985 mm (1.4955 in.)
Part C: 31 .985 mm (1.2592 ln.)
If the outer diameter is less than the minimum, replace the out·
put shaft.
Using a dial indicator, check the shaft runout.
(c)
Maximum runout: 0.03 mm (0.0012 in.)
If the run out exceeds the maximum, replace the output shaft.
OUTPUT SHAFT