EM-30
Gasket
N
Seal
4 - 5
Width
N
ENGINE MECHANICAL
Wi d t h
1. 5
8.
FIPG
- Seal
mm
(a)
(b)
HINT:
Avoid applying an excessive amount to the surface.
(c)
(d)
HINT:
Avoid applying an excessive amount to the surface.
mm
-
TIMING CHAIN
2ZZ-GE:
INSTALL TIMING CHAIN COVER AND WATER PUMP
Remove any old packing (FIPG) material and be careful
not to drop any oil on the contact surfaces of the timing
chain cover, cylinder head and cylinder block.
•
Using a razor blade and a gasket scraper, remove
all the old packing (FIPG) material from the gasket
surfaces and sealing grooves.
•
Thoroughly clean all components to remove all the
loose material.
•
Using a non-residue solvent, clean both sealing
surfaces.
Apply seal packing to the timing chain cover as shown in
the illustration.
Seal packing:
Part No. 08826-00100 or equivalent
•
Instal! a nozzle that
ing.
•
Parts must be assembled within 3 minutes of ap
plication. Otherwise the material must be removed
and reapplied.
Immediately remove nozzle from the tube and rein
stall cap.
Install the 2 gasket to the timing chain cover as shown in
the lllustration.
locations as shown in the illustra
Apply seal packing to
4
tion.
Seal packing:
Part No. 08826-00080 or equivalent
•
Install a nozzle that has been cut to a
- 0.20 in.) opening.
Parts must be assembled within 3 minutes of ap
plication. Otherwise the material must be removed
and reapplied.
•
Immediately remove nozzle from the tube and rein
stall cap.
has
been cut to a 1
mm open
.5
mm (0. 1 6
4 - 5