Power Steering Vane Pump Reassembly; Install Side Plate; Install Cam Ring; Install Vane Pump Rotor - Toyota Celica 2000 Repair Manual

SR-30
N
N
Inscribed Mark
N
-
STEERING
REASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
COAT PARTS INOICATED B Y ARROWS WITH POWER
1 .
STEERING FLUID (See page SR-22)
INSTALL VANE P U M P SHAFT WITH VANE PUMP
2.
PULLEY
3.

INSTALL SIDE PLATE

Coat 2 new 0-rings with power steering fluid, and install
(a)
them to the side plate.
Align the dent of the side plate with the dent of the front
(b)
housing, and install the side plate.
NOTICE:
Make sure that the side plate is installed facing in the cor�
rect direction.

INSTALL CAM RING

4.
Align the dent of the cam ring with the dent of the side plate, and
instal! the cam ring with the inscribed mark facing outward.
Round End
5.

INSTALL VANE PUMP ROTOR

Install the vane pump rotor with the inscribed mark facing
{a)
outward.
Install a new snap ring to the vane pump shaft.
(b)
6. INSTALL 10 VANE PLATES
Install the 1 0 vane plates with the round end facing outward.
7. INSTALL REAR HOUSING
(a} Coat a new 0-ring with power steering fluid, and install
it to the rear housing.
Align the straight pin of the rear housing with the dents of
(b)
the cam ring, side plate and front housing, and install the
rear housing with the 4 bolls.
Torque: 22 N.m (220 kgf.cm, 1 6 ft . lbf)
Install the rear bracket with the boll.
(c)
Torque: 44 N·m (440 kgf.cm, 32 ft.lbf)
8. INSTALL OIL PRESSURE SWITCH
Torque: 21 N.m (210 kgf.cm, 15 ft·lbf)
POWER STEERING VANE PUMP