�
CLUTCH
CLUTCH
REASSEMBLY
COAT PARTS WITH LITHIUM SOAP BASE GLYCOL
1 .
GREASE, AS SHOWN IN ILLUSTRATION
2.
INSERT PiSTON WITH SPRING INTO CYLINDER
3.
INSTALL PUSH ROD
Install the washer to the push rod.
(a)
(b)
Push the push rod into tho piston, using snap ring pliers,
install the snap ring.
INSTALL BOOT TO CYLINDER
4.
TEMPORARILY INSTALL LOCK NUT AND CLEVIS
5.
CLOJ]3
INSTALL INLET UNION
6.
(a)
Install a new grommet.
(b)
Instal! the inlet union.
Using a pin punch (3 mm) and hammer, drive in the slotted
(c)
spring pin.
0QTI19
MASTER CYLINDf:: r l
CL-7