Toyota Celica 2000 Repair Manual page 417

MX-16
-
MANUAL mANSAXLE (C6Ql
•
Set SST to the rear radial ball bearing inner race securely,
drive in the bearing with a hammer.
SST
Remove the spacer.
(c)
007699
15. REMOVE INPUT SHAFT REAR RADIAL BALL BEAR­
ING AND 6TH GEAR
Using 2 screwdrivers and a hammer, tap out the snap
(a)
ring.
HINT:
At the time of reassembly, please refer to the following item.
Select a snap ring from the table below that will make the thrust
clearance of the No. 3 clutch hub less than 0.1 mm (0.0039 in.).
Mark
A
8
c
D
E
Using SST, remove the rear radial ball bearing and 6th
(b)
gear.
SST
HINT:
At the time of reassembly, please refer to the following item.
Set SST to the rear radial ball bearing inner race securely, drive
in the bearing with a hammer.
SST
Remove the needle roller bearing and spacer.
(c)
005001
MANUAL TRANSAXLE ASSEMBLY
0951 7-1 201 0
M;uk
Thickness mm (in.)
G
1.70 {0.0669)
1.75 (0.0689) H
J
1 .80 {0.0709)
1.85 {0.0728) K
1.90 {0N48)
L
1.95 (0.0768) M
09950-4001 1 (09951-04 0 1 0 , 09952-0401 0,
09953-04030, 09954-04 0 1 0 , 09955-04021 ,
09957-{)4010, 09958--0 4 01 1 )
095 1 7- 1 20 1 0
mm{in.)
ThickMss
2.00 {0.0787)
2.05 (0.0807)
2.10 (0.0827)
2. 15 (0.0846)
2.20 (0.0866)
2.25 (0.0886)