Differential Case Reassembly; Assemble Differential Case; Install Tapered Roller Bearing - Toyota Celica 2000 Repair Manual

MANUAL TRANSAXLE
REASSEMBLY

ASSEMBLE DIFFERENTIAL CASE

1 .
(a) Install the correct thrust washers and side gears.
Refer to the table below, select thrust washers which will
ensure that the backlash is within the specification. Try to
select washers of the same size for both sides.
0.0 5 - 0.20 mm (0.0020 - 0.0079 in.)
Standard backlash:
bor,o21
ThiCkness mm (1n.)
Install the thrust washers and side gears in the differential
(b)
case.
Install the pinion shaft.
(c)
Using a dial indicator, check the side gear backlash.
(d)
Measure the side gear backlash while holding one pinion
toward the differential case.
Standard backlash:
0.05 - 0.20 mm (0.0020 - 0.0079 in.)
If the backlash is not within the specification, install a thrust
washer of different thickness.
(e) Using a pin punch and hammer, drive in the straight pin
through the differential case and hole in the pinion shaft.
(f) Using a chisel and hammer, caulk the p"1n holes around
the circumference of the differential case.
2.
Ring gear side:

INSTALL TAPERED ROLLER BEARING

Using SST and a press, install the tapered roller bearing.
SST
NOTICE:
When replacing the tapered roller bearing outer race, re·
place the tapered roller bearing along with it.
HINT:
Set SST to the bearing inner race securely.
DIFFERENl tAL
CASE
0.95 \0.0374)
1 .00 {0 0394)
1 .05 (0.0413)
0935()-32014 (0935 1 -32120. 09351-321 40)
MX-49
� ' " " ' "'
Thtckncss mm {in.}
1 . 1 0 {0.0433)
1 . 1 5 (0.0453)
1.20 (0.0472}