Differential Case Disassembly; Remove Ring Gear; Inspect Side Gear Backlash; Disassemble Differential Case - Toyota Celica 2000 Repair Manual

MX-46
MANUAL TRANSAXLE
DISASSEMBLY

REMOVE RING GEAR

1.
Place match marks on the ring gear and differential case.
{a)
Remove the 8 bolts.
(b)
Using a copper hammer, tap on the ring gear to remove
(c)
it from the differential case.
[)00855
Vehicle speed sensor drive gear side:
2.
REMOVE TAPERED ROLLER BEARING FROM DIF­
FERENTIAL CASE
Using SST, remove the tapered roller bearing.
(a )
SST
SST
HINT:
Set the claw of SST to the bearing inner race securely.
Remove the vehicle speed sensor drive gear.
(b}
Ring gear side:
3.
REMOVE TAPERED ROLLER BEARING FROM DIF­
FERENTIAL CASE
Using SST, remove the tapered roller bearing.
SST
HINT:
Set the claw of SST to the bearing inner race at the position
where the differential case is indented.

INSPECT SIDE GEAR BACKLASH

4.
Using a dial indicator, measure the backlash of one side gear
white holding one pinion toward the differentia\ case.
0.05 - 0.20 mm (0.0020 - 0.0079 in.)
Standard backlash:
If the backlash is not within the specification, install the correct
thrust washer to the side gears.

DISASSEMBLE DIFFERENTIAL CASE

5.
Using a pin punch and hammer, drive out the straight pin.
(a)
Remove the pinion shaft from the differentia! case.
(b)
Remove the 2 pinions and side gears with the 4 thrust
(c)
washers from each gear.
DIFFERENTIAL CASE
0995().-00020, 0995().-00030, 0995().-40011
(09957-04010), 0995().-6001 0 (09951-00350)
0995G-40011, 0995().-6001 0 (09951-00350)