Toyota Celica 2000 Repair Manual page 451

MX-50
/
.
I
!
�
; II .-!.-
SST
•
9.9 :t.
---<;__,.--
I I
I I
I
,
MANUAL TAANSAXLE
5.
{a )
(b)
(c)
6.
(a)
(b )
(c)
-
(d)
[
(e)
0.3mm
']
�
�
DOT.J71
(I)
NOTICE:
When replacing the tapered roller bearing outer race, re­
place the tapered roller bearing along with it.
DISASSEMBLE DIFFERENTIAL CASE
Using a pin punch and hammer, drive out the straight pin.
Remove the pinion shaft from the differential case.
Remove the 2 pinions and side gears with the 4 thrust
washers from each gear.
Transmission case side:
IF NECESSARY, REPLACE OIL SEAL AND TAPERED
ROLLER BEARING OUTER RACE
Using SST, pull out the tapered roller bearing outer race
and shim.
0961 2-6501 4
SST
Using SST and a hammer, drive out the oil seal.
09226-1 0010
SST
Using SST and a hammer, drive in a new oil seal.
SST 09226-1 0010
Drive in depth: 9.9 ± 0.3 mm (0.390
Coat the lip of the oil seal with MP grease.
Place the shim into the differential case.
Using SST and a press, install the tapered roller bearing
outer race.
09950-60020 (09951-00710), 09950-7001 0
SST
(09951-07150)
:t
0.012 in.)