Toyota Celica 2000 Repair Manual page 780

SUPPLEMENTAL RESTRAINT SYSTEM
o m (33ft)
-
FRONT PASSENGER AIR BAG ASSEMBLY
Install the SST
(e)
Connect the connectors of the 2 SST to the front passen·
ger airbag assembly connector.
SST 09082-00700, 09082-00760
NOTICE:
To avoid damaging the SST connector and wire harness,
do not lock the secondary lock of the twin lock, Also, se­
cure some slack for the SST wire harness inside the tires.
Deploy the airbag .
(f)
Connect the SST red clip to the battery positive (+)
( 1 )
terminal and the black clip to the battery negative
(-) terminaL
(2) Check that no one is within 1 0 m {33 ft) area around
the tire which the front passenger airbag assembly
is tied to.
Press the SST activation switch and deploy the air·
(3)
bag.
HINT:
The airbag deploys simultaneously as
tivation switch lights up.
(g) Dispose of the front passenger airbag assembly.
CAUTION:
•
The front passenger airbag assembly i s very hot
when the airbag is deployed, so leave it alone for at
least 30 minutes after deployment.
•
Use gloves and safety glasses when handling a front
passenger airbag assembly with the deployed airbag.
•
Always wash your hands with water after completing
the operation.
•
Do not apply water, etc. to a front passenger airbag
assembly with the deployed airbag.
Remove the front passenger airbag assembly from
{ 1 )
the tire.
Place the front passenger airbag assembly in a vi­
(2)
nyl bag, tie the end tightly and dispose of it in the
same way as other general parts disposaL
DEPLOYMENT WHEN DISPOSING OF FRONT PAS­
3.
SENGER AIRBAG ASSEMBLY WITH AIRBAG
DEPLOYED IN COLLISION
Dispose of the front passenger airbag assembly.
RS-35
SST ac­
the LED of the