Fuel System - Toyota Celica 2000 Repair Manual

SF-2
Vinyl
Bag�/
SFI SF! SY TEM
When installing the battery, be especially careful not to in­
(b)
correctly connect the positive (+) and negative (�) cables.
Do not permit parts to receive a severe impact during re­
(c)
moval or installation. Handle all SFI parts carefully, espe­
cially the ECM.
Be careful during troubleshooting as there are numerous
{d)
transistor circuit, and even slight terminal contact can
cause further troubles.
(f)
Do not open the ECM cover.
(e)
When inspecting during rainy weather, take care to pre­
vent entry of water. Also, when washing the engine
compartment, prevent water from getting on the SF! parts
and wiring connectors.
Parts should be replaced as an assembly.
(g)
Care should be taken when pulling out and inserting wir­
(h)
ing connectors.
Release the lock and pull out the connector, pulling
( 1 )
on the connectors.
(2) Fully insert the connector and check that it is locked.
(f)
Use SST for inspection or test of the injector or its wiring
connector.
SST 09842-30080
7.

FUEL SYSTEM

When disconnecting the high fuel pressure line, a large
(a)
amount of gasoline win spill out, so observe these proce­
dures.
Disconnect the fuel pump connector.
( 1 )
Start the engine. After the engine has stopped on
(2)
its own, turn the ignition switch to LOCK.
Disconnect the fuel tube (See page SF-11 ).
(3)
(4) Drain the fuel remained inside the fuel tube.
Prevent the disconnected fuel tube from damaging
(5)
and mixing foreign objects by covering them with a
vinyl bag.