Toyota Celica 2000 Repair Manual page 453

MX-52
N
SST
'- -- -�
NSAXLE
MANUALTRA
REASSEMBLY
1 .
ASSEMBLE DIFFERENTIAL CASE
Install the correct thrust washers and side gears.
(a)
Refer to the table below, select thrust washers which wil!
I
•
ensure that the backlash is within the specification. Tr
I
select washers of the same size for both sides.
·-
.... .. �.(
Standard backlash:
�so21
0.05 - 0.20
Install the thrust washers and s1de gears
(b )
case.
{ c) Install the pinion shaft.
Using a dial indicator, check the side gear backlash.
(d)
Measure the side gear backlash while holding one pinion
toward the differential case.
Standard backlash:
0.05 - 0.20
If the backlash is not within the specification, install a thrust
washer of different thickness.
Using a pin punch and hammer, drive in the straight pin
(e)
(I)
through the differential case and hole in the pinion shaft.
Using a chisel and hammer, caulk the pin holes around
the circumference of the differential case.
2. Ring gear side:
INSTALL TAPERED ROLLER BEARING
Using SST and a press, install the tapered roller bearing.
SST
NOTICE:
When replacing the tapered roller bearing outer race, re�
place the tapered roller bearing along with it.
HINT
Dw:J55
Set SST to the bearing inner race securely.
(0.0020 - 0.0079 in.)
mm
Thickness mm (1n.)
0.95 (0.0374)
1.00 (0.0394)
1 .05 \0.041 3)
(0.0020 - 0.0079 ln.)
mm
0935(}-320 1 4 (09351-32120. 09351-32140)
.,
""""
j · -'J
Thicl<ness mm (in.)
1 . 1 0 {0.0433)
1 . 1 5 {0.0453)
1.20 (0.0472)
m
the d1tferent1al