Toyota Celica 2000 Repair Manual page 421

MX-20
MANUAL TRANSAXLE
REMOVE REVERSE IDLER GEAR SHAFT LOCK BOLT
24.
AND GASKET
Sealant:
Part No. 0883:Hl0080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 29 N.m (300 kgf.cm, 22 ft·lbf)
REMOVE SNAP RING FROM NO. 2 SHIFT FORK
25.
SHAFT
Using 2 screwdrivers and a hammer, tap out the snap ring.
26. REMOVE STRAIGHT SCREW PLUG, SEAT, SPRING
AND BALL
Using a hexagon wrench, remove the 3 straight screw
(a}
plugs.
Sealant:
Part No. 0883:Hl0080, THREE BOND 1 344, LOCTITE
242 or equivalent
Torque: 25 N.m (250 kgf.cm, 1 8 ft·lbt)
Using a magnetic linger. remove the
{b)
000308
balls.
27. REMOVE STRAIGHT SCREW PLUG
Using a hexagon wrench, remove the 2 straight screw plugs.
Sealant:
Part No. 0883:Hl0080, THREE BOND 1 344, LOCTITE
242 or equivalent
Torque:
Plug A: 1 3 N·m (130 kgf.cm, 9 ft·lbt)
Plug B: 39 N·m (400 kgf.cm, 29 ft.lbl)
28. REMOVE TRANSMISSION CASE
Remove the 1 6 bolts.
(a)
Torque: 29 N·m (300 kgf.cm, 22 ft·lbf)
Carefully tap the transmission case with a plastic hammer
(b)
and remove it.
000310
HINT:
At the time of reassembly, please refer to the following item.
Apply FIPG to the transaxle case side, as shown in the illustra­
tion.
FIPG:
Part No. 08826--00090, THREE BOND 1281 or equiva­
lent
MANUAL TRANSAXLE ASSEMBLY
seals, springs and
3