Check Fit Between Piston And Piston Pin; Remove Piston Rings; Disconnect Connecting Rod From Piston - Toyota Celica 2000 Repair Manual

�
ENGINE MECHANICAL
GYUNDER
25.

CHECK FIT BETWEEN PISTON AND PISTON PIN

Try to move the piston back and forth on the piston pin.
If any movement is fell, replace the piston and pin as a set.
26.

REMOVE PISTON RINGS

Using a piston ring expander, remove the 2 compression
(a)
rings.
(b) Remove the 2 side rails and oil ring by hand.
HINT:
Arrange the piston rings in the correct order only.
Mll7�
27.

DISCONNECT CONNECTING ROD FROM PISTON

(a) Using a small screwdriver, pry out the 2 snap rings.
1ZZ-FE:
(b)
Gradually heat the piston to 80 - 90 " C (
1ZZ-FE:
(c)
Using a plastic-faced hammer and brass bar, lightly tap
out the piston pin and remove the connecting rod.
HINT:
The piston and pin are a matched set.
Arrange the pistons, pins, rings, connecting rods and
bearings in the correct order.
(d) 2ZZ-GE :
Remove the pin and connecting rod from the piston.
BLOCK
EM-97
-
194 �F).
176