Inspect Brush Holder Insulation; Inspect Gear Teeth; Inspect Clutch - Toyota Celica 2000 Repair Manual

Ohmmeter
Terminal C
Continuity
S
.
wttc h Bod
y
-
STARTING

INSPECT BRUSH HOLDER INSULATION

1 1 .
Using an ohmmeter, check that there is no continuity between
the positive (+) and negative (-) brush holders.
If there is continuity, repair or replace the brush holder.

INSPECT GEAR TEETH

12.
Check the gear teeth on the pinion gear, idler gear and clutch
assembly lor wear or damage.
If damaged, replace the gear or clutch assembly.
damage.

INSPECT CLUTCH

13.
Rotate the clutch pinion gear clockwise, and check that it turns
freely.
Try to rotate the clutch pinion gear counter-clockwise and
check that it locks.
If necessary, replace the clutch assembly.
14. DO MAGNETIC SWITCH PULL-IN COIL OPEN
Ohmmeter
CIRCUIT TEST
Using an ohmmeter, check that there is continuity between ter-
�� � - C.
II there is no continuity, check and replace the magnetic switch.
[fll
15. DO MAGNETIC SWITCH HOLD-IN COIL OPEN
Ohmmeter
CIRCUIT TEST
Using an ohmmeter, check that there is continuity between ter·
minal 50 and the switch body.
If there is no continuity, replace the magnetic switch.
50
STARTER
ST-9
B