Input Turbin Speed Sensor On-Vehicle Repair - Toyota Celica 2000 Repair Manual

AX-4
AUTOMATIC TRANSAXLE (U341El
INPUT fURBIN SPEED SENSOR
INPUT TURBIN SPEED SENSOR
ON-VEHICLE REPAIR
1 . REMOVE BATIERV
REMOVE ECM AND ECM CASE
2.
3. REMOVE ECM BRACKET
REMOVE INPUT TURBIN SPEED SENSOR
4.
Disconnect the connector.
(a)
Remove the bolt and input turbin speed sensor.
(b)
Remove the 0-ring from the input turbin spee d sensor.
(c)
INSTALL INPUT TURBIN SPEED SENSOR
5.
{ a)
Coat a new 0-- r ing with ATF and install it to the input turbin
speed sensor.
Install the input turbin speed sensor with the bolt.
(b)
Torque: 5.4 N.m (55 kgf.cm, 48 in.·lbf)
(c) Connect the connector.
INSTALL ECM BRACKET
6.
Torque:
Bolt: 1 8 N·m (185 kgf·cm, 13 ft.lbf)
Nut: 12 N·m (120 kgf.cm, 9 ft.lbf)
INSTALL ECM AND ECM CASE
7.
Torque: 6.9 N·m (70 kgf . cm, 61 in.·lbf)
8. INSTALL BATIERY
'"' '""" "