Viewing The Topology Table Using Edm - Avaya 4524GT Configuration Manual

Variable
Status
NmmLstChg
NmmMaxNum
NmmCurNum

Viewing the topology table using EDM

Use this procedure to display the topology table.
Procedure steps
1. From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostics tree, double-click Topology.
4. In the work area, click the Topology Table tab.
Variable definitions
Use the data in this table to help you understand the topology table display.
Variable
Slot
Port
IpAddr
SegId
MacAddr
Configuration — System
Specifies whether Avaya topology is on (topOn) or off (topOff) for the
device. The default value is topOn.
Indicates the value of sysUpTime the last time an entry in the network
management MIB (NMM) topology table was added, deleted, or modified.
If the table has not changed since the last cold or warm start of the
agent.
Indicates the maximum number of entries in the NMM topology table.
Indicates the current number of entries in the NMM topology table.
Indicates the slot number in the chassis in which the topology message
was received.
Indicates the port on which the topology message was received.
Indicates the IP address of the sender of the topology message.
Indicates the segment identifier of the segment from which the remote
agent sent the topology message. This value is extracted from the
message.
Indicates the MAC address of the sender of the topology message.
Viewing the topology table using EDM
Value
Value
April 2011 283